Hydroseeding is often used to economically seed large areas of lawns, especially on commercial projects. This grass planting process is fast, economical, and efficient and is used for a wide variety of applications. Depending on watering and/or rainfall frequencies a properly hydroseeded area usually will show results in as little as three days, and can be fully established in three weeks or less.

Finn hydroseeded ground starts growing grass from the root first allowing the root system to go deep in the ground where moisture is at it's greatest, making a very drought tolerant lawn. Comparatively, sod that is already established is forced to grow leaf stock while trying to establish a root system, making a solid sodden yard very weak in drought type condition.

Here is a check-list for winterizing your hydroseeder®.
A. Pump
1. Check impeller wear plate tolerance-adjust or replace
2. Inspect casting for wear
3. Replace seal if leaking
4. Drain water from pump casing, then pour in a quart of oil & spin by hand to prevent rust
5. Remove lubricator cup & fittings, clean & repack with soft soda based grease
B. Tank
1. Exterior can be cleaned of lime & fertilizer by spraying on fuel oil (caution-consult local ordinances) or vinegar & washing off several days later. Touch up with paint
2. Interior should be cleaned & spot painted
3. Inspect all tank bearings & seals. Replace if necessary
C. Piping
1. Inspect all rubber seals & gaskets
2. Inspect all piping clamps & coupler
3. On units with plug type discharge valves, remove & disassemble valve, clean grease grooves & the large plug in the bottom of the valve & repack
4. Flush all hoses, reels & piping